ALARM-Alarm setting: When the battery capacity is below the set capacity, the percentage and battery symbol will flash and the alarm will beep once every 10s. ![]() If the discharge continues, the voltage value will flash, and the alarm will beep once every 10s. LOW V-Zero capacity voltage: When the voltage is lower than the set value, the capacity will be automatically set to 0%.HIGH V-Full capacity voltage: When the voltage is higher than the set value, the capacity will be automatically set to 100%. ![]() CAP-Preset capacity: An initial capacity has been set at the factory, please set it according to the real capacity of your battery.Click or key to select the setting items: Press the key for 3s to enter setting menu Ģ. Then set the displayed AH capacity as the preset AH capacity.įor Sealed Lead Acid batteries it is recommended to set the AH lower than the usable rating after conducting a capacity test or consulting the battery manufacturer. Now charge the battery fully and the displayed AH capacity should be the actual usable capacity. Check and reset the actual capacity: If you find the displayed capacity doesn't match the actual capacity during use, please check and reset the actual capacity.įor Lithium batteries discharge the battery to 0% and hold the "down" key for 3s to set the capacity to 0, then set the preset capacity as large as possible. This will only have to be done on initial installation of the Renogy Battery Monitor or if the Battery Bank is replaced.ģ. Capacity calibration: On first use, the percentage and capacity are not the actual value, you need to calibrate the capacity to either 100% or 0%.įirst set the usable AH capacity of the battery as the preset AH capacity.įor Lithium and Sealed Lead Acid batteries to calibrate to 100% charge the battery fully and hold the "up" key for 3s to set the capacity to 100%įor Lithium batteries to calibrate to 0% discharge the battery completely and hold the "down" button key for 3s to set the capacity to zero. If the deviation is large, please check the connection.Ģ. Then charge or discharge the battery and check whether the display current is equal to the actual current. If the screen has no response, please check the connection. Connect and check the current: Power on after completing the connection as shown, the screen should display capacity percentage. Operation Interface description Use stepsġ. Then put The Renogy Battery Monitor into the rectangular orifice, and make sure the tabs are locked. First, open a rectangular orifice on your equipment panel according to the size. The Renogy Battery Monitor is fixed by tabs, so it is easy to install. The shunt must be series connected to the negative circuit, DO NOT connect to the positive circuit. One end of the wire connects to positive of battery, another end connects to B+ of Shunt (either one is ok).įinally connect the Shunt to the Renogy Battery Monitor by the shielded wire and the screen of the Renogy Battery Monitor display should turn on.Īttention: Please connect as shown. P- of shunt connects to P- of output and C- of charge. ![]() B- of shunt connects to B- of the battery. USER MANUAL BATTERY MONITOR Identification of Parts Dimension Installation Connection/Setupįirst, connect the Shunt in series to the negative circuit of your battery.
0 Comments
Leave a Reply. |